PCC Aerostructures Monterrey is a vertically integrated aerospace machining, sheet metal, and assembly center conveniently located in Monterrey, Nuevo Leon, Mexico between the aerospace manufacturing areas of Chihuahua, Sonora, and Querétaro.
The 85,000 sq. ft. facility manufactures small structural assemblies and complex sheet metal components using in-house Nadcap and OEM approved non-destructive test, heat treatment, and surface treatment processes to control cost, quality, and schedule.
Formerly Noranco Monterrey Division, the facility was acquired by PCC in October 2015.
Capabilities
Hard Metal Machining
- 2-axis turning to 11 x 12 in (279 x 305 mm)
- 4-axis milling to 60 x 27 x 25 in (1,523 x 685 x 634 mm)
Aluminum Machining
- 2-axis turning to 13 x 19 in (330 x 482 mm)
- 4-axis milling to 41 x 20 x 20 in (1,041 x 508 x 508 mm)
Sheet Metal Processes
- CNC Routing
- Press Brake Forming
- Hydroforming
- Stretch Forming
- Draw Forming
Post Machining and Forming Processes
- Aluminum Heat Treat
- Non-destructive Testing
- Chemical Processing and Paint
Bench Assembly and Kitting
- Small structural assemblies and components
Products
Small Aluminum Assemblies and Kits
- Supports
- Fittings
- Stiffeners
Complex Sheet Metal Components
- Cabin Air System Components
- Seal Retainers
- Nacelle and Thrust Reverser Component Kits
Supplier Quality Documents
